Genotoxic effect of ciprofloxacin during photolytic decomposition monitored by the in vitro micronucleus test (MNvit) in HepG2 cells

Purpose

Ciprofloxacin (CIP), a broad-spectrum, second-generation fluoroquinolone, has frequently been found in hospital wastewaters and effluents of sewage treatment plants. CIP is scarcely biodegradable, has toxic effects on microorganisms and is photosensitive. The aim of this study was to assess the genotoxic potential of CIP in human HepG2 liver cells during photolysis.

Methods

Photolysis of CIP was performed in aqueous solution by irradiation with an Hg lamp, and transformation products were monitored by HPLC-MS/MS and by the determination of dissolved organic carbon (DOC). The cytotoxicity and genotoxicity of CIP and of the irradiated samples were determined after 24?h of exposure using the WST-1 assay and the in vitro micronucleus (MN) test in HepG2 cells.

Results

The concentration of CIP decreased during photolysis, whereas the content of DOC remained unchanged. CIP and its transformation products were not cytotoxic towards HepG2 cells. A concentration-dependent increase of MN frequencies was observed for the parent compound CIP (lowest observed effect level, 1.2???mol?L^?1). Furthermore, CIP and the irradiated samples were found to be genotoxic with a significant increase relative to the parent compound after 32?min (P?P?Conclusions Photolytic decomposition of aqueous CIP leads to genotoxic transformation products. This proves that irradiated samples of CIP are able to exert heritable genotoxic effects on human liver cells in vitro. Therefore, photolysis as a technique for wastewater treatment needs to be evaluated in detail in further studies, not only for CIP but in general.     

The occurrence of lithium in the environment of the Jordan Valley and its transfer into the food chain

Lithium is found in trace amounts in all soils. It is also found in plants and in nearly all the organs of the human body. Low Li intake can cause behavioral defects. Thus, this study was conducted to investigate the concentration and distribution of water-soluble Li in soils of the Jordan Valley and its concentration in citrus trees and some important food crops in view of the significant implications of Li for human health. The concentration of soluble Li was measured in 180 soil samples collected at two depths (0–20 and 20–40 cm) whereas its content was determined in fully expanded leaves collected from citrus and different vegetable crops. Concentrations of soluble Li in soils vary from 0.95 to 1.04 mg l⁻¹ in topsoil and from 1.06 to 2.68 mg l⁻¹ in subsoil, while Li concentration in leaves ranged from 2 to 27 mg kg⁻¹ DM. Lithium concentrations in leaves of crops of the same family or different families vary with location in the valley; i.e., they decreased from north to south. It is concluded that soluble Li in soils and the plant family did not solely affect Li transfer in the food chain. In addition, soil EC, Ca, Mg, and Cl, which increased from north to south, might adversely affect plant Li uptake. The current study also showed that consuming 250–300 g FW of spinach day⁻¹ per person is recommended to provide consumers with their daily Li requirement necessary for significant health and societal benefits.     

Methane flux and oxidation at two types of intermediate landfill covers

Methane emissions were measured on two areas at a Florida (USA) landfill using the static chamber technique. Because existing literature contains few measurements of methane emissions and oxidation in intermediate cover areas, this study focused on field measurement of emissions at 15-cm-thick non-vegetated intermediate cover overlying 1-year-old waste and a 45-cm-thick vegetated intermediate cover overlying 7-year-old waste. The 45 cm thick cover can also simulate non-engineered covers associated with older closed landfills. Oxidation of the emitted methane was evaluated using stable isotope techniques. The arithmetic means of the measured fluxes were 54 and 22 g CH(4) m(-2)d(-1) from the thin cover and the thick cover, respectively. The peak flux was 596 g m(-2)d(-1) for the thin cover and 330 g m(-2)d(-1) for the thick cover. The mean percent oxidation was significantly greater (25%) at the thick cover relative to the thin cover (14%). This difference only partly accounted for the difference in emissions from the two sites. Inverse distance weighing was used to describe the spatial variation of flux emissions from each cover type. The geospatial mean flux was 21.6 g m(-2)d(-1) for the thick intermediate cover and 50.0 g m(-2)d(-1) for the thin intermediate cover. High emission zones in the thick cover were fewer and more isolated, while high emission zones in the thin cover were continuous and covered a larger area. These differences in the emission patterns suggest that different CH(4) mitigation techniques should be applied to the two areas. For the thick intermediate cover, we suggest that effective mitigation of methane emissions could be achieved by placement of individualized compost cells over high emission zones. Emissions from the thin intermediate cover, on the other hand, can be mitigated by placing a compost layer over the entire area.     

Use of a biologically active cover to reduce landfill methane emissions and enhance methane oxidation

Biologically-active landfill cover soils (biocovers) that serve to minimize CH4 emissions by optimizing CH4 oxidation were investigated at a landfill in Florida, USA. The biocover consisted of 50 cm pre-composted yard or garden waste placed over a 10-15 cm gas distribution layer (crushed glass) over a 40-100 cm interim cover. The biocover cells reduced CH4 emissions by a factor of 10 and doubled the percentage of CH4 oxidation relative to control cells. The thickness and moisture-holding capacity of the biocover resulted in increased retention times for transported CH4. This increased retention of CH4 in the biocover resulted in a higher fraction oxidized. Overall rates between the two covers were similar, about 2g CH4 m(-2)d(-1), but because CH4 entered the biocover from below at a slower rate relative to the soil cover, a higher percentage was oxidized. In part, methane oxidation controlled the net flux of CH4 to the atmosphere. The biocover cells became more effective than the control sites in oxidizing CH4 3 months after their initial placement: the mean percent oxidation for the biocover cells was 41% compared to 14% for the control cells (p<0.001). Following the initial 3 months, we also observed 29 (27%) negative CH4 fluxes and 27 (25%) zero fluxes in the biocover cells but only 6 (6%) negative fluxes and 22 (21%) zero fluxes for the control cells. Negative fluxes indicate uptake of atmospheric CH4. If the zero and negative fluxes are assumed to represent 100% oxidation, then the mean percent oxidation for the biocover and control cells, respectively, for the same period would increase to 64% and 30%.     

Scaling methane oxidation: from laboratory incubation experiments to landfill cover field conditions

Evaluating field-scale methane oxidation in landfill cover soils using numerical models is gaining interest in the solid waste industry as research has made it clear that methane oxidation in the field is a complex function of climatic conditions, soil type, cover design, and incoming flux of landfill gas from the waste mass. Numerical models can account for these parameters as they change with time and space under field conditions. In this study, we developed temperature, and water content correction factors for methane oxidation parameters. We also introduced a possible correction to account for the different soil structure under field conditions. These parameters were defined in laboratory incubation experiments performed on homogenized soil specimens and were used to predict the actual methane oxidation rates to be expected under field conditions. Water content and temperature corrections factors were obtained for the methane oxidation rate parameter to be used when modeling methane oxidation in the field. To predict in situ measured rates of methane with the model it was necessary to set the half saturation constant of methane and oxygen, K_m, to 5%, approximately five times larger than laboratory measured values. We hypothesize that this discrepancy reflects differences in soil structure between homogenized soil conditions in the lab and actual aggregated soil structure in the field. When all of these correction factors were re-introduced into the oxidation module of our model, it was able to reproduce surface emissions (as measured by static flux chambers) and percent oxidation (as measured by stable isotope techniques) within the range measured in the field.     

Risk-optimal highway design: Methodology and case studies

Highway geometric design in mountainous areas has been a typical challenge. The combination of short horizontal curves and restricted right-of-way is a common ground for contemplating design exception in British Columbia, Canada. In practice, collision modification factors (CMFs) are advocated as quantitative measures of changes in road features on safety. However, in many situations, there are no CMFs in the literature to predict the safety impact of changing particular road features. An important example of these road features is sight distance restriction on horizontal curves. A mechanism for risk measurement has been proposed in earlier work to assist designers in comparing the safety impact of different deviations from sight distance requirements. This paper attempts to answer the questions as to whether it is possible to reduce overall risk and achieve consistency in such reduction without demanding wider right-of-way. This problem was formulated in a multi-objective optimization framework. Following this methodology, it was possible to achieve an average reduction in risk of 25% on the nine critical cross-sections. This reduction in risk was achieved without demanding wider right-of-way and without creating measurable increase in expected collision frequency due to independent re-dimensioning of different geometric elements. On theoretical grounds, this paper represents another step into the direction of developing fully probabilistic geometric design standards. On practical grounds, this paper provides an important decision mechanism that enables the efficient use of available right-of-way for new highway construction. Case studies in this paper have been applied on a major highway development in British Columba, Canada.     

Determination of Hydrocarbons in Mussels from the Egyptian Red Sea Coast

Mussels (Brachidontes Sp.) collected in April 2000 from the Red Sea coastal of Egypt in order to determine the contamination by hydrocarbons. The study included 11 sampling stations covering about 450 Km of the Egyptian Red Sea coast for the first time. Total concentrations of 20 aliphatics (average 0.105 ng g(-1) of wet weight) and sixteen polycyclic aromatic hydrocarbons (PAHs) (average 5452 ng g(-1) of wet weight) were generally lower in comparison with those reported for some of the published surveillance and monitoring studies of coastal areas from various regions. These results suggest that the coastal area in the Red Sea of Egypt might be considered as a relatively unpolluted.